The picture show below will describe this better than I can, but our 100 ft hose just blew autonomously at the faucet connection and information technology seems some slice that would go on the inside (possibly a safe or plastic gasket?) barbarous out or within the hose. I figured this should be an easy function to supersede just take no idea what part/size I should be looking for. Don't want to throw out a relatively new 100' hose just for one small office!

Photo of hose end after it fell apart

UPDATE:

Run across Polypipe Wrangler's answer beneath... And here's a moving picture that shows what he's talking almost. I was able to use a wire to pull this out and volition try to detect a mode to secure information technology better so it doesn't blow out over again.

Inner tubing scooped out and reconnected

asked Jul 18, 2020 at 18:08

1

  • very excellent question & illustrations & repair development!!

    Jul 21, 2020 at 17:38

one Respond 1

The metal function you are belongings is the outer non-kinking protective piping. There should be a flexible rubbery tube inside. I promise it hasn't retreated far down the piping because it has to get over the affront on the plumbing equipment shown.

In one case the tubing is on, then yous tin can run across if information technology only compresses confronting the outer pipe (about likely) or needs a special role.

answered Jul 21, 2020 at v:22

2

  • I shone a flashlight down the hose and finally could tell what y'all were talking about hither! The inner hose was down a good human foot or so and I was able to scrape information technology back upwardly with a wire.

    Jul 21, 2020 at fifteen:53

  • splendid solution & repair suggestions and repair developments!!

    Jul 21, 2020 at 17:37

Not the answer you're looking for? Browse other questions tagged watering tools repair hoses tool-maintenance or ask your own question.